TRANS CHEM COATINGS
MATERIAL SAFETY DATA SHEET
Manufacturers Name: Trans Chem Coatings Date Prepared: 4/1/2000
Street Address: 1680 Miller Ave.. Los Angeles CA 90063
Emergency No.: 1- 800-421-2849 Information: 213-747-7725
Product Class: Polyurethane Enamel V.O.C. : <2.4 Lbs/Gal
Product Name: Polyurethane 8800 Series -Base Part 1 of 2
INGREDIENTS/ IDENTITY INFORMATION
N-Butyl Acetate (SARA III)
NIOSH (RTECS) AF7350000
OSHA PEL: 150 ppm
ACGIH TLV 150 ppm
Perchloroethylene (SARA III) (CERCLA)
NIOSH (RTECS) KX3850000
OSHA PEL: 100 ppm
ACGIH TLV 25 ppm
ACGIH STEL 100 ppm
Glycol Ether PM Acetate (Propylene Glycol Monomethyl Ether Acetate)
NIOSH (RTECS) AI8925000
OSHA PEL: n/k
ACGIH TLV n/k
Methyl Amyl Ketone (2-Heptanone)
NIOSH (RTECS) MJ5075000
OSHA PEL: 100 ppm
ACGIH TLV 50 ppm
Toluene (IARC CARC 3)
NIOSH (RTECS) XS5250000
OSHA PEL: 100 ppm
ACGIH TLV 100 ppm
Xylene (SARA III)
NIOSH (RTECS) ZE2100000
OSHA PEL: 100 ppm/ 150 STEL
ACGIH TLV 100 ppm/ 150 STEL
PHYSICAL CHEMICAL CHARACTERISTICS
Physical Form : Liquid
Color : n/a
Odor : Of Solvent
pH : n/a
Boiling Point : Approx. 250 deg F (121 C) (Perchloroethylene)
Melting/Freezing Point : Not established
Solubility in Water : Insoluble
Specific Gravity : Approx 1200 g/l
Bulk Density : Approx. 10.2 lbs/gal
% Volatile by Weight : Approx. 30 to 35%
Vapor Pressure : n/a
FIRE & EXPLOSION HAZARD DATA
Flash Point : 81 deg F (27.2 C) Butyl Acetate
Upper Explosive Limit (UEL) (%) :
Lower Explosive Limit (LEL) (%) : 3.0 Butyl Acetate
Upper Explosive Limit (UEL) (%) : 7.9 Methyl Amyl Ketone
Lower Explosive Limit (LEL) (%) : 1.1 Methyl Amyl Ketone
Auto-Ignition Temperature : Not established
Extinguishing Media : Dry Chemical; Carbon Dioxide; Form; Water
Special Fire Fighting Procedures : Full emergency equipment with self-contained breathing apparatus and full protective clothing should be worn by firefighters. During a fire, irritating, highly toxic gases may be generated by thermal decomposition or combustion.
Unusual Fire / Explosion Hazards : Isolate from heat, electrical equipment, sparks and open flame. Closed container may explode when contaminated with water (CO2 evolved). Solvent vapors may be heavier than air.
Stagnant air may cause vapors to build up and travel along the ground to an ignition source which may result in a flash back to the source of the vapors.
This product is stable
Conditions to avoid: moisture, excessive heat, sources of ignition
Incompatibility: avoid water, reactive materials
Hazards decomposition products: carbon dioxide/ carbon monoxide/ metal oxides
Hazards polymerization: None
HEALTH HAZARD DATA
Proposition 65 statement: WARNING,This product contains a chemical(s) known to the state of California to cause cancer and/or birth defects.
Acute Hazard: Burning, tearing, drying or cracking of skin, coughing, chest pain, difficulty in breathing, nausea, vomiting, abdominal discomfort, diarrhea. Medical conditions generally aggravated by exposure-any respiratory or skin condition
Possible routes of entry: inhalation, ingestion, skin absorption
Emergency and first aid procedures: Eyes: Flush with water for 15 minutes. Skin: Wash with soap and water, not with solvents. Inhalation: Remove to fresh air from exposure area., give CPR if necessary. Ingestion: Do not induce vomiting. In all cases, obtain immediate medical attention.
PRECAUTIONS FOR SAFE HANDLING AND USE
Precautions to be taken in handling storage:
Keep containers closed when not in use. Do not store above (115 deg. F ) keep from freezing. Empty containers may contain product residue. Do not cut, puncture or weld containers. All label warning must be observed, until container has been cleaned or reconditioned, or properly disposed of. Mix material well to proper specifications.
Spills: Wear air supplied NIOSH approved respirator for major unventilated release. Cover with absorbent material and keep loosely covered for 48 hours. Clean up residue with solvent.
Ventilate area; remove spills with inert absorbent.
Waste disposal method: Dispose in chemical disposal area or in a manner that complies with local state and federal regulations, do not incinerate closed containers.
Use solvent resistant protective gloves, chemical splash safety glasses, and protective solvent resistant apron.
DOT ID#: UN1263
DOT proper shipping name: Paint or Paint Related Material
DOT Label: Flammable Liquid
DOT Class 3